CAPB-101 - page 5

The basic slip fit inlet is standard on
Chicago’s pressure blowers and is
cast into the inlet coverplate.
Diameters are available from4" to
10" for convenient fit of ductwork.
The variety of inlet sizes helps fine
tune performance for direct drive
blowers.
The outlet is cast into each housing
half in 4" to 8" diameters for a slip
fit duct connection.
INLETS/OUTLETS
SHAFT SEAL
RUGGEDMOTOR BASE
BLOWER ARRANGEMENTS
A virgin teflon sheet is bolted to the
drive side of the housing. The seal is
designed to reduce airstream leak-
age and contamination through the
blower shaft opening in the housing.
Aheavy gauge steel pedestal holds
themotor firmly in place. The
flanged andwelded construction
provides exceptional rigidly.
Motors fromrecognizedmanufac-
turers are factorymounted and
tested at running speed for
vibration and balance.
DIRECT DRIVE
• Arrangement 4, with c-face flange
and/or footmountedmotor.
• Arrangement 4V, vertical mount
with c-face flangemountedmotor.
Includes flanged inlet.
BELT DRIVE
• Arrangement 1 includes heavy
steel bearing pedestal.
• Arrangement 9 as above except
includesmotor slide base. Motor
and drives are factorymounted.
5
1,2,3,4 6,7,8,9,10,11,12,13,14,15,...16
Powered by FlippingBook